Ifyou are playing those games with that GPU you frankly don't really need to boost to 4.2ghz. Your main limitation is the GPU. If you wanted your laptop to run cooler you can just disable turbo boost, most likely with negligible if not zero performance loss. I think there are some posts that discuss how to disable turbo boost in the registry Thisis turbo boost. Turbo boost is a function that automatically applies a small OC to help with heavy loads (in two steps, step one is partial OC, second is full OC and disables half the cores while active, this is helpful in heavy single thread situations) . this is a default function and is present on non k processors and i had thought it Theother auto settings should work well, 4.8 to 5.1 ghz without needing to tweak. Gamers should get easy 5.0 ghz on all cores. No problem." Basically synch all your cores to 1 multiplier so you can avoid flactuations.Temps shouldn't even be an issue if you're only gaming. Ifthe title says capture card, it was recorded using this device: see the unboxing for the 10th Gen I5-10400 CPU: https://youtu. Ihave a Zephyrus G15, and read that disabling turbo boost would help keeping temperatures down. I was wondering if this would help the computer last longer; and if it would be worth it for rendering. Thanks! 3. 1. Blender 3D computer graphics software Software Information & communications technology Technology. 1 comment. Alienwareand Dell Gaming Computer Overclocking CPU Overclocking vs. Intel Turbo Boost. While you can make permanent changes to the processor, memory, and motherboard settings to increase the overall speed by overclocking. Intel Turbo Boost Technology accelerates the processor for peak loads. It automatically allows processor cores to run precisionboost overdrive. disable. help. 1. Go to solution Solved by glenalz81, December 30, 2020. You could set a negative offset voltage on the CPU, this will help temps also. -0.050v is the most i would set, anymore and you're likely to lose performance. Theamount of turbo boost available is like hot water in a bath tub. When you run a CPU at full speed, this drains the water out of the tub and it can take some time before the tub fills back up and full turbo boost is available again. If you are using the Disable and Lock feature, nothing will be reported for the MMIO power limit because Strategy#1: Disable Turbo Boost while on battery. I've written a very simple registry tweak that will bring back the maximum CPU frequency control in power settings. By setting the maximum CPU Finally disable "Turbo Boost Short Power Max Enable." You'll never reach these levels of power usage, but removing all power caps allows you to push your silicon to the limits. Overclocking P Dlbx.